User Manual

Update Procedures:
10
(1)Please make sure the connection between gimbal control module and PC are correct, and
check whether or not the module version can be seen.
(2)Please connect the DATA/FC of module and PC through a USB cable
(3)Click for upgrade. Wait until all the procedures have been done.
Attention:
If something wrong occurs during update, please check the connection and power supply.
Also, make sure you have correctly installed the drive program. You can repeat upgrading
for several times until your device is broken.
Moreover, you could screenshot the upgrade procedures and send your concerns or
problems through the feedback on the top right corner of the assistant software.
V. Troubleshooting
Angle is
not level
Gimbal
vibrates.
Image of the
video is not
stable enough.
Red light
blinks quickly.
1. Error of sensors is too large.
2. Tx is not centered.
1. The camera is not screwed down.
2. Motor torque is too large.
1. Vibration is too large;
2. Damping balls are not fixed.
3. Motor torque is too small.
1. Connection cable between gimbal
controller and its main body becomes loose.
2. Gimbal stall protection goes far
beyond ten times.
1. Calibrate sensors.
2. Center the Tx.
1. Screw down the camera and lens screws.
2. Decrease motor torque value slightly.
1. Reduce the vibration of the multi-rotors;
2. Tightly fix the damping balls.
3. Slightly increase the value of motor torque.
1. Check and fix the wiring cables;
2. Make sure whether or not there is
resistance to gimbal rotation. Then,
power cycle the gimbal.
VI. Port Descriptions
Gimbal Main Controller Port
PWR
DATA/FC
5V/RC/AV
DEBUG
Motor Drive & Sensor Module Port
Power Port
Gimbal Main Controller Assistant Software Update & Gimbal Data Input Port
5V Power Output & Receiver Input & AV-OUT Port
Debug Port. Do not connect it to any external device.
ASSEMBLY SECTION
组装说明书
T4-3d
TA R O T AV I A T I O N T E C H N OL O G Y C O. ,LT D
塔 罗 航 空 科 技 有 限 公 司