User Manual

11
TIPs：
Battery
Receiver
Video
Flight Control
6. Gimbal Working Mode
ASSEMBLY SECTION
5
Power Supply:3S-6S Li (11V-26V)
* If you choose a battery to power up the gimbal and
multi-rotor, please make sure this battery meets
requirements of both components.
1. Common Receiver: connect the corresponding port of
common receiver to CHI-CH7 channels of gimbal controller.
Set related parameters in RECEIVER TYPE and RC
MAPPING in assistant software.
2. FutabaSBUS Receiver/ SBUS-2 Receiver: connect
SBUS receiver to CH7 channel of gimbal controller. Set
related parameters in RECEIVER TYPE and RC MAPPING
in assistant software.
3. Satellite Receiver: connect Satellite receiver to DSM
port of gimbal controller. Set related parameters in
RECEIVER TYPE and RC MAPPING in assistant software.
If binding is not successful in DSM2-1 or DSMX-1,
please choose DSM2-2 or DSMX-2 to bind.
Connect the wireless video transmission module to AV
port through a 3.5mm AV cable.
Gimbal can work without Tarot Multi-rotor Flight Control
Module, but the performance might be inuenced:
1. Angle offset might occur when the accelerated state lasts
for a long time.
2. In AL Mode, drifts might occur in pan angle due to gyro offset.
If you are pursuing a perfect performance, please connect the
gimbal and Tarot Multi-rotor Flight Control Module to the CH8
channel of gimbal controller.
You should select a three-positioned switch in the transmitter for working
mode. Please connect the corresponding port of the receiver to any
channel ofCH1-CH7channels of the gimbal controller.Set RC MAPPING
in the assistant software. For different positions, use endpoint ne tune
function to set. Please refer to the MODE Channel section in assistant
software for detailed information.