Technical Specifications

4. Starting at the bottom riser, measure and cut a plank to fit the riser. The plank for each riser shall be cut flush with the top of
the existing stair tread. Using a good quality construction adhesive, apply a serpentine bead to the back of the plank. Press
plank firmly into place.
5. Measure and cut a plank and stair nosing to fit the stair tread. Dry fit each piece to make sure they fit properly. Apply
construction adhesive to the stair tread and spread evenly over the entire tread with a 1/16” x 1/16” x 1/16” notched trowel.
Position plank and stair nosing and press firmly into place.
6. If installing over a wood substrate, predrill holes through the stair nosing and fasten with finishing nails. Set nails so they are
just below the surface of the stair nosing.