SDS

Date of issue/Date of revision
: 2015-10-14. Date of previous issue
: 2015-10-07.
Version : 1.07
6/12
826-12
0000109118
Section 8. Exposure controls/personal protection
Individual protection measures
Hygiene measures :
Wash hands, forearms and face thoroughly after handling chemical products, before
eating, smoking and using the lavatory and at the end of the working period.
Appropriate techniques should be used to remove potentially contaminated clothing.
Wash contaminated clothing before reusing. Ensure that eyewash stations and safety
showers are close to the workstation location.
Selection of personal protective equipment (PPE) is to be established by the employer
performing a PPE hazard assessment. In the U.S.A, OSHA requires completion of a
documented PPE hazard assessment as described in 29 CFR 1910.132.
Eye/face protection
Skin protection
Hand protection
Body protection
:
Safety eyewear complying with an approved standard should be used when a risk
assessment indicates this is necessary to avoid exposure to liquid splashes, mists,
gases or dusts. If contact is possible, the following protection should be worn, unless
the assessment indicates a higher degree of protection: chemical splash goggles.
:
Chemical-resistant, impervious gloves complying with an approved standard should be
worn at all times when handling chemical products if a risk assessment indicates this is
necessary. Considering the parameters specified by the glove manufacturer, check
during use that the gloves are still retaining their protective properties. It should be
noted that the time to breakthrough for any glove material may be different for different
glove manufacturers. In the case of mixtures, consisting of several substances, the
protection time of the gloves cannot be accurately estimated.
:
Personal protective equipment for the body should be selected based on the task being
performed and the risks involved and should be approved by a specialist before
handling this product. When there is a risk of ignition from static electricity, wear anti-
static protective clothing. For the greatest protection from static discharges, clothing
should include anti-static overalls, boots and gloves.
Other skin protection :
Appropriate footwear and any additional skin protection measures should be selected
based on the task being performed and the risks involved and should be approved by a
specialist before handling this product.
Respiratory protection :
Use a properly fitted, air-purifying or air-fed respirator complying with an approved
standard if a risk assessment indicates this is necessary. Respirator selection must be
based on known or anticipated exposure levels, the hazards of the product and the safe
working limits of the selected respirator.
Dry sanding, flame cutting and/or welding of the dry paint film will give rise to dust and/
or hazardous fumes. Wet sanding/flatting should be used wherever possible. If
exposure cannot be avoided by the provision of local exhaust ventilation, suitable
respiratory protective equipment should be used.
Appearance
Physical state
Color
Odor
pH
Melting point
:
Liquid.
:
Not available.
:
Not available.
: Not available.
:
Not available.
Boiling point :
65 - 240 °C (149 - 464 °F)
Flash point
Evaporation rate
:
Closed cup: -21°C (-5.8°F)
:
Highest known value: Greater than 1. (tetrahydrofuran) compared with butyl acetate
Lower and upper explosive
(flammable) limits
:
Lower: 1% Upper: 12%
Vapor pressure
Vapor density
:
143 mm Hg (19.019 kPa) (Highest known value: tetrahydrofuran)
: > 1 (Air = 1) (Calculation method)
Volatility :
80.63% (w/w)
Density :
0.976 g/cm³
Section 9. Physical and chemical properties