Operation Manual

10
Targus Wireless RF Mouse
Troubleshooting
What do I do if the RF mouse does not work?
• Make sure that the polarity of the batteries is correct. The
positive (+) and negative (-) ends of each battery must
match the positive (+) and negative (-) connections in the
battery housing.
• Check that the receiver’s USB connector is firmly
attached to the USB port on your computer.
• Verify that the device drivers are installed.
• Make sure you have established a radio link between the
mouse and its receiver. See “Establishing a
Communications Link” on page 5
Receiver Interface USB version 1.1
Operating Voltage Mouse: 1.6~5V
Receiver: 5V (powered by the USB
port)
Batteries 2 AAA Alkaline
Operating Current Mouse: 26mA or lower
Receiver: Below 15mA
Mouse Standby Current Below 4mA
Mouse Sleep Mode Current Below 50uA
Modulation Type FSK
Transmission Rate 4K bps
Error Detection 8-bit CRC