User's Manual
Table Of Contents
- Contents
- 0. Revision History
- 1. Introduction
- 2. Product Overview
- 3. Get Started
- 3.1. Open the Case
- 3.2. Install a SIM Card
- 3.3. Install the Internal Backup Battery
- 3.4. Switch on the Backup Battery
- 3.5. Install the External GPS Antenna
- 3.6. Power Connection
- 3.7. Ignition Detection
- 3.8. Digital Inputs
- 3.9. Analog Inputs
- 3.10. Digital Outputs
- 3.11. Device Status LED
- 3.12. Serial Port/UART Interface
- 3.13. Reset Button
- 4. FCC Statement
GV300TP User Manual
TRACGV300TPUM001 - 13 -
3.3.Install the Internal Backup Battery
GV300TP has an internal backup Li-ion battery, put the battery line on the right of plastic clip
which can avoid the battery line to be damaged when install the screw of PCBA.
Figure 5.Backup Battery Installation
3.4.Switch on the Backup Battery
To use the GV300TP backup battery, the switch must be in the ON position. The switch on the
case and the ON/OFF position are shown below.
Figure 6.Switch and ON/OFF Position
Note:
1. The switch must be in the “OFF” position when the GV300TP is shipped on an aircraft.
2. When the switch is in the “OFF” position, the battery cannot be charged or discharged.