User's Manual
Table Of Contents
- Contents
- 0. Revision History
- 1. Introduction
- 2. Product Overview
- 3. Get Started
- 3.1. Open the Case
- 3.2. Install a SIM Card
- 3.3. Install the Internal Backup Battery
- 3.4. Switch on the Backup Battery
- 3.5. Install the External GPS Antenna
- 3.6. Power Connection
- 3.7. Ignition Detection
- 3.8. Digital Inputs
- 3.9. Analog Inputs
- 3.10. Digital Outputs
- 3.11. Device Status LED
- 3.12. Serial Port/UART Interface
- 3.13. Reset Button
- 4. FCC Statement
GV300TP User Manual
TRACGV300TPUM001 - 12 -
3.Get Started
3.1.Open the Case
Figure 3.Open the Case
3.2.Install a SIM Card
Open the case and ensure the unit is not powered (unplug the 16Pin cable and switch the
internal battery to the OFF position). Slide the holder right to open the SIM card holder. Insert
the SIM card into the slot as shown below with the yellow colour contact area facing down. Take
care to align the cut mark. Close the SIM card holder. Close the case.
Figure 4.SIM Card Installation