Safety Data Sheets (SDS)

Safety Data Sheet - LeakBarrier Self-Adhering Starter Roll Page 2 of 8
HAZARD RATING (NFPA) HAZARD RATING (HMIS®)
NFPA – National Fire Protection Association
HMIS® is a registered trademark of the American Coatings Association
Degree of Hazard
0 - Minimal (Insignificant)
1 - Slight
2 - Moderate
3 - Serious (High)
4 - Severe (Extreme)
SECTION 3 – COMPOSITION / INFORMATION ON INGREDIENTS
CHEMICAL NAME COMMON NAME CAS NUMBER PERCENT BY WEIGHT
Asphalt Asphalt Flux 8052-42-4 8-30
Oxidized Asphalt Coating Asphalt 64742-93-4 13-52
Styrene-Butadiene-Styrene SBS Rubber 9003-55-8 1-7
Petroleum Hydrocarbon Resin Resin 68527-25-3 0.1-2
Mineral Oil Oil 64741-96-4 0.1-2
Calcium Carbonate Limestone 1317-65-3 9-40
Continuous Filament Glass Fiber Glass Mat 65997-17-3 3-8
Coal Slag Fines Slag 68476-96-0 8-30
Polyethylene Poly Film 9002-88-4 1-3
Polypropylene Poly Film 9003-07-0 1-3
Note:
NA = Not Available
NE = Not Established
SECTION 4 – FIRST AID MEASURES
INHALATION
If product is heated, exposure to fumes, vapors, or mists may cause irritation of the nose and
throat. Drink water to clear throat or blow nose to clear. Use of product in properly ventilated
areas is not expected to cause adverse effects. Remove to fresh, uncontaminated air. Give
artificial respiration and/or oxygen by trained personnel, if necessary and get immediate
medical attention.
SKIN
Remove contaminated clothing and wash exposed skin with soap and water. If irritation
develops or persists, seek medical attention. If contacted by hot asphalt, cool with ice or water;
HEALTH 1
FLAMMABILITY 1
REACTIVITY 0
SPECIAL NOTICE -
HEALTH 1
FLAMMABILITY 1
PHYSICAL HAZARD 0
PERSONAL PROTECTION X