Technical Specifications

Rev 8/2019 © 2019 Tarco All Rights Reserved. Printed in U.S.A.
Application
 For ease of application, unroll ReflectPlus and allow it to
relax for at least 15 minutes.
 Apply the membrane starting at the lowest point,
working the way to the highest point.
 Arrange the membrane in a straight manner, fold back
the sheet, and remove the exposed release film, taking
care not to displace the sheet.
 Working from the center out, roll the sheet onto the
substrate, taking care to avoid wrinkles and ridges.
ReflectPlus must be set straight. Repeat this process for
the other half of the sheet.
Warranty
LeakBarrier ReflectPlus is warranted to be free from manufacturer’s defects.
NOTE: All statements, information and data, given herein are believed to be accurate and reliable but are presented without guaranty, warranty or responsibility of any
kind, expressed or implied, except as may be indicated otherwise in this literature. Statements or suggestions concerning possible use of our products are made
without representation or warranty that any such use is free of patent infringement and are not recommendations to infringe any patent.
Tarco
One Information Way, Suite 225

Little Rock, AR 72202
Voice: 501-945-4506

800-365-4506
Fax: [phone]

www.tarcoroofing.com
Properties
 Apply succeeding courses in like manner, as in steps above.
 Use minimum 4 inch side lap and 6 inch end laps, and
stagger all end laps by at least 3 feet.
 At the T-Joints (where an end lap and next overlapping
course intersect) and other laps where the self-adhesive
compound comes into contact with the film, use a hot air
welder to ensure a water tight seal.
 Roll the entire membrane surface, paying special
attention to side laps, end laps and T-joints. Roller weight
shall be 70 lb. minimum for low slope (≤2:12 pitch) and
28 lb. minimum for steep slope (>2:12 pitch).
Product Data
Width 36 in
Length 33 ft 6 in
Weight 33 lb
(nominal)
Thickness 45 mil
(nominal)
Gross Coverage 100 sq ft
Rolls per Pallet 30
Property Typical Value Test Method
Tensile Strength 40 lbf/in ASTM D1970
Elongation, Rubberized asphalt 600% ASTM D1970
Adhesion to Plywood @ 75
0
F 40 lb/ft width ASTM D903
Adhesion to Plywood @ 40
0
F 15 lb/ft width ASTM D903
Low temperature flexibility 0.1 in ASTM D1970
Thermal Stability, max -20°F ASTM D1970
Nail sealability Pass ASTM D1970
Permeance 0.05 perms max ASTM E96
 Acceptable substrates for adhesion of LeakBarrier
membranes can be found at the Tarco website
 For best results, surface may be primed with an ASTM
D41 Primer prior to installation of ReflectPlus.When
primer is used, ensure the primer is fully dry prior to
application of ReflectPlus.
 When surface is primed, ensure the primed surface is dry
to the touch and install the membrane within the same
work day. If not, the surface shall be re-primed.