Product Manual

Tapplock Box 2.0
enterprise fingerprint enrollment device
Quick Start
Overview
Hint
Model: TL304A
Enroll up to 3000 fingerprints
AES 128-bit encrypted and secure
Over 500 days of battery life per 4-hour charge.
Simply recharge by USB-C.
Check remaining power via Tapplock app.
1
2
Log in on the Tapplock
Enterprise app and
follow instructions
to setup.
Fingerprint placing position:
Do not use fingertip to enroll
*Warning: It depends on enterprise
account registration procedure.
Download
the Tapplock
Enterprise app on
the IOS App Store
or Google Play.
FCC notice
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without restriction.
This device complies with Industry Canada licence-exempt RSS
standard(s).
Operation is subject to the following two conditions:
(1) This device may not cause interference, and (2) This device must accept
any interference, including interference that may cause undesired operation
of the device.
Le présentappareilestconforme aux CNR d'Industrie Canada applicables
aux appareils radio exempts de licence. L'exploitationestautorisée aux deux
conditions suivantes: (1) l'appareil ne doit pas produire de brouillage, et (2)
l'utilisateur de l'appareildoit accepter tout brouillageradioélectriquesubi,
mêmesi le brouillageest susceptible d'encompromettre le fonctionnement.
The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without restriction.
Tapplock Box 2.0
Charging Cable
Product Manual
Visit Tapplock.com for
newest updates, instructions and FAQ.
Contact us by emailing:
[e-mail]
Status Indicator
Included in this box
Features
Customer Support
Users need to send verify fingerprint command on
the app to verify fingerprints.
Bluetooth searching
GreenSTATUS Blue
Blinking
Red Yellow
Bluetooth connected
Fingerprint recognized
Fingerprint error
Low battery (at 10%)
Charging
100% charged
Upgrading firmware
©2016 Tapplock Corp. All rights reserved.
121 Richmond St W, Toronto, ON
Canada M5H 2K1
Led Status
Indicator
Led Status Indicator
Start Button
Reset Button
Fingerprint
Sensor
USB-C
Charging Port
FOLD FOLD
FOLD FOLD COVER
BACK
60 mm
100 mm
le dispositif a été évalué à satisfaire l'exigence générale de l'exposition aux rf.
l'appareil peut être utilisé dans des conditions d'exposition portatif sans restriction.