User Manual



41
Code ID setting
Code ID is a one-or-two-character string used to represent the symbol upon a
succeeding reading. If you want application to transmit Code ID, you must
set Code ID transmission to be enabled. Refer to the chapter of
Scan Code ID（2Bit；00~FF； 65* ‘e’）C
Insert String 1 Selection
Scan one digits parameter (0~6) that: 0: no string insert to the barcode; 1~6:
insert to the barcode G1~G6 to the barcode.
Scan Insert String 1（1Bit；0~6；0*）
Insert String 2 Selection
Scan Insert String 2（1 Digit；0~6；0*）