Owner manual

- 3 -
Memory function
*ON OFF
Read mode setup
*Turn off light source after reading Trigger ON/OFF
Continue scan/Trigger Disable Twinkle
Continue scan/Auto-inductive Enable Twinkle/ Auto- inductive Enable
Note：
1、 Trigger ON/OFF：Light source will shine when press switch，
otherwise light source won’t shine, Keep pressing until read some
information, then the light source will go out.
2、Continue scan/Trigger Disable：The same information will be
only read once unless move to other information, then move the reader
to the barcode again and scan.
3、Twinkle：The same information will be only read once unless
move to other information, then move the reader to above of the
barcode/no information in front of the reader, the light source will start