User's Manual

7
3. Peel the red liner from the adhesive tape on the IR interface adapter.
4. Insert the IR interface cable through the drilled hole from outside to inside the meter.
5. Arrange the IR interface so that the flat side of the sensor is toward the center of the
meter. The legs of the meter will guide the sensor positioning.
6. Make sure you position the sensor in place as straight as possible. The split cylindrical
protrusion on the adhesive side of the sensor will fit into the 3/8" drilled hole.
7. Apply pressure gently for one minute over the flat side of the interface adapter.
Figure 4a Figure 4b
Figure 4: IR Serial Interface Adapter
Attach Module Power Leads to Meter Bus Bars
1. Select the appropriate power clips for the size of the bus bars in the meters.
2. Using needle nose pliers, attach a pair of power clips to the Fast-on tabs on the ends of
the power leads of the TC-2200 module.
3. With the needle nose pliers attach the power clips to the bus bars at the top side of the
meter as shown in Figure 5.
Figure 5: Connecting the module power leads to the meter power bus bars
Mount the TC-2200 Module
1. Once the power leads are attached to the meter bus bars, press the power leads together
around the left side of the meter.