User's Manual

Installing the TC-2200

BEFORE YOU BEGIN

1. Assemble the necessary equipment: Tantalus TC-2200 Module Installation Kit and

required tools and materials.

TC- 2200 MODULE INSTALLATION KIT

Each kit for installing a Tantalus TC-2200 module includes the following items:

• One TC-2200 module

• One IR serial interface

In addition to the retrofit kit the following items are required:

• Mounting screws for GE I-70-S meter: UNF 4-48 x ¾” (Two required per meter)

• Mounting screws for ABB AB-1 meter: UNF 6-40 x ¾” (Two required per meter)

• Power clips to attach to bus bars (Two required per meter): Part number dependant on

bus bar diameter.

Tantalus P/N Bus Bar Diameter

13811300003A 0.20” – 0.22”

13811300003B 0.18”

13811300003C 0.26” – 0.28”

13811300003D 0.32” – 0.36”

REQUIRED TOOLS AND MATERIALS

• 3/8” electric hand drill and 3/8” drill bit

• Drill alignment jig (recommended for GE meters)

• Needle nose pliers

• #2 Phillips screwdriver

• Rubbing alcohol

• Soft cloth or paper towels

• Disk marking template and paint pen

• Anti-static wrist strap

• Computer for programming TC-2200 module (Desktop, laptop or handheld

computer)

• Tantalus TC-2200 module programming software

• DC power supply, 6 – 8 VDC, for powering the module for programming

• TC-2200 Programming Cable