User's Manual

TUNet NC-900 Network Collector Install Guide page 5
Doc No. KT-100036
3 :: DT-400 Programming Software Guide
Configuring an NC-900 Network Collector using the programmer is similar to configuring any home
network router. You must choose a dynamic or static network addressing scheme, and then enter the
address of the NS-2000 Network Server.
The DT-400 runs in two modes:
• The “TUNet User” account which is used to program the NC-90 devices. This account can also
view or download programming log files over USB.
• The “System Administrator” account which is used to change the network settings of the DT-
400. This account also is used to set up the date and time zone for the programmer.
An online help file is available on the DT-400 which will provide more detailed explanations. If you do
not know the network address, or if you are unclear about which addressing scheme to choose for the
NC-90, speak to your Network Administrator.
Note: Please contact Tantalus Technical Support for passwords to the two accounts.