User's Manual

TUNet NC-900 Network Collector Install Guide page 3
Doc No. KT-100036
2.1 Programming Instructions for the Meter Shop (NC-900)
Ensure that you have a DT-400 Programming Station .
1. Remove the NC-900 from the box. Plug the Ethernet cable into RJ-45 port.
2. Ensure that the DT-400 Programmer is powered and connected to the NC-900 using a
crimped-style Ethernet cable.
3. Power up the NC-900.
4. Start the programming software on the DT-400 and follow the prompts. Refer to
Section 3 :: DT-400 Programming Software Guide on page 5 for more information.
When the process is finished, the DT-400 programmer will provide notification on whether the
programming was successful.