User's Manual

Page 18 Tantalus Systems Corp.
Released: 2010/1/31
7. Select Options and select Configure DeviceIP. Set this to the IP ADDRESS of the NC-90 to be
reprogrammed (In this case it is 10.0.0.10).
8. Connect a network cable from the NC-90 to the DT-400 and insert it into a meter collar.
9. Apply power to the NC-90. Wait for the lights to change to flashing orange or flashing red
indicating that it is ready to be reprogrammed. The device is now ready to communicate with
the DT-400.
10. Follow the standard programming instructions as described in Section 3.1.
Note: After a statically configured device has been reprogrammed to use dynamic addressing,
the DT-400 must be changed back to Option 1 under the “sysadmin” account to resume
reprogramming of new NC-90’s. Alternatively, the DT-400 may be turned off then restarted to
get back into the default dynamic programming mode.