User's Manual

Page 16 Tantalus Systems Corp.
Released: 2010/1/31
After a short delay, the program will echo the assigned IP address to the operator. In special
circumstances, this option may also be used to change the network setting of the NC-90 if it was
mistakenly configured for a Static Network Address and the wrong IP was programmed, or if you must
configure it back for DHCP Addressing.
Once you have configured this setting, the settings will be automatically saved and you will be logged
out of the account. You must log in again to the System Admin account if you want to make further
changes.
3.3.4 Setting the DT-400 Date/Time
A new DT-400 programmer will require the date, time and time zone changed. This will ensure that the
programming logs record the correct time. Follow the prompts on the DT-400 screen to update.
3.3.5 Setting the Unit ID
If there is more than one programmer available, it may be beneficial to change the ID of the device. This
can be helpful when reconciling the log files.
The default unit ID is set to tunet02. The DT-400 will add this tag to any log files exported to the usb
stick.
3.3.6 Shutdown
Select this option to shutdown the programmer. This is the same as pressing the power button. It is not
recommended to remove the battery while the programmer is operating.