User's Manual

Overview
4 Proprietary and Confidential 2004-07-23
About This Document
The NC-2200 Installation Guide describes the requirements to complete a typical installation. Site conditions will
vary from site to site however the basic requirements for power, grounding and antenna connection will be the same.
Overview of Contents
This document contains the following sections:
• Overview describes the Tantalus Utility Network.
• Site Requirements describes the basis site requirements that apply to all sites.
• Equipment Description describes the major subsystems in the NC-2200
• Installation describes the required power, antenna and network connections
• Initial Configuration and Testing describes the minimum initial configuration required to put the NC-2200
into service.
FCC Compliance Statement
Changes or modifications not expressly approved by Tantalus Systems Corp. may void your authority to operate the
equipment described in this manual.
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to
radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in
which case the user will be required to correct the interference at his own expense.
FCC RF Exposure Warning
Users and installers must be provided with appropriate antenna installation instructions and transmitter operating
conditions, including antenna co-location requirements of §1.1307(b)(3), for satisfying RF exposure compliance.
The antenna used with this transmitter must not exceed 6 dBd. The antenna should be mounted to provide a
separation distance of at least 4 meters from all persons. Unauthorized antenna installations may violate FCC
regulations.
Referenced Documents
NC-2200 Network Administration Guide, P/N 900.0003