User's Manual

Sensors?
Contact installer to replace Keypad and
Controller.
“Zone Name”
The Keypad will display the first component that
may be replaced
Replace?
Press the No key to select the next component or
press the Yes key to replace this component .
Remove Component
The keypad will wait two minutes for you to
And Press Yes
remove component and press the Yes key. The
Keypad will beep.
Enter New Comp
Enter the new component’s Serial Number . If an
error is made press No
# [XXXXXXXXX]
to re-enter. Add Batteries to the new component.
# is [XXXXXXXX]
Press Yes to confirm the Serial Number or No to
return to previous
Confirm?
Start Walk Test?
Press Yes to start walk test.
Walk Test Active
The keypad will display this message during the
To Stop Press No
walk test. When a sensor is activated the Keypad
will sound a series of beeps.
6. System Messages
Another Keypad
Only one keypad may be used at a time.
In Use
Communication
The Controller was unable to communicate with the
monitoring station.
Failure
Contact your installer for service and press Bypass to
clear message.
Low Battery
Change the battery on the named device or bypass the
“Zone/Device name”
zone. Contact installer if device is the controller.
Sensor Fault
Contact your installer for service. Press Bypass to
bypass the sensor “Zone/Device name” or clear the
message.