User's Manual

an alarm if a protected door or window is opened. At the
end of the exit delay the Red light stays on.
4. Disarming The System
The system can be disarmed as described below.
When entering through a Entry door, the keypad will beep and the entry delay
will begin, reminding you to disarm the system. The keypad will display the
following message…
System Armed
Enter your access code.
Enter Code
The Red light will go OFF and the keypad will beep. If
an error is made entering the code, re-enter your code
correctly.
System Disarmed
Green light is On if the system is ready.
No Alarm Memory
System Disarmed
If an alarm occurred while the system was armed, this
Alarm in Memory
message will appear and the Red light will flash. After 5
seconds the Keypad will display…
“Zone name”
The zones that caused the alarm are displayed.
View next?
Press Yes to view additional zones
Clear Alarm
Press Yes to clear
Memory?
5. Menu/Test Key
Press the Menu/Test key for the following:
• Zone Bypassing
• Setting Time and Date
• Door Chime
• Changing Access Codes
• Replacing System Components
• Installation Walk test
Zone Bypass
Entrance/exit and fire zones cannot be bypassed.
Display shows….
Zone Open
Press Menu/Test
or
Enter any access code
System Ready