Quick Start Guide
LED Functions
LimitLED-Whenilluminatedthisindicatesthatthesystem
is approaching clipping. An occasional icker of the red
LEDontheloudestpeaksisacceptable.IfthisLEDremains
redformorethanthedurationofbriefdynamicpeaks,or
lightscontinuouslythenthesystemisbeingoverdriven.If
theredLEDilluminatesexcessively:
•Reducetheinputlevel(seeinterfacepanel)
•Reducetheoutputlevelofthemixer,orothersourceto
thespeaker.
Signal LED – The Green LED indicates that a useable
signalispresentattheinput.
Power LED – When AC mains is connected to the
speakerandthepowerswitchisturnedon,thebluelower
LEDwillilluminate.
Audio Connections
The signal input & link connectors are fully balanced.
Whenconnectingabalancedsignalbesuretowiretothe
followingstandard:
SIGNAL XLR CONNECTOR
Hot(+) Pin2
Cold(-) Pin3
Shield(GND) Pin1
Inastandardbalancedinterconnectiontherearetwosignal
conductorsandashield.Theshieldisnormallyreferenced
togroundatoneorbothends.Manytimestheshieldis
liftedatoneend,usuallyattheinputtoeliminate“ground
loops”ornoise.Thisshouldbedoneonlyasalastresort;
althoughitwillreducehum,theshieldscanactasradio
antennas and pick up radio frequency interference from
theenvironment.
Multiple enclosures may be driven from a single audio
source;simplyplugthesignalsourceoutputintotherst
XLRinputsocket,andpatchthatspeaker’sXLRlinktothe
nextspeaker’sXLRinputsocket.
Gain Structure and Limiting
The VXNET gain structure is designed to allow a low-
levelsourcedevicetodrivetheloudspeakertofulloutput.
Maximum specied SPL will be achieved with a 4 dBu
inputsignal.Thereissufcientheadroominthesignalpath
toaccommodateinputlevelsof10oreven20dBu,with
highqualitycompressionengagedasneededtomaintain
sonicintegritywithoutclipping.
Equalisation
The VXNET loudspeaker requires no equalisation or
correction to overcome system limitations; equalisation
is necessary only to compensate for difcult acoustic
environments.
Rigging and Safety Procedures
TheinstallationofTannoyProfessionalloudspeakersusing
the dedicated hardware should carried out only by fully
qualied installers, in accordance with all the required
safetycodesandstandardsthatareappliedattheplace
ofinstallation.
WARNING: As the legal requirements for ying change
fromcountrytocountry,please consultyourlocal safety
standards ofce before installing any product. We also
recommend that you thoroughly check any laws and
bylawspriortoinstallation.Formoredetailedinformation
onrigginghardwareandsafetyprocedures,pleaseconsult
the full VX Series and VXP Series Hardware Manual
availableatwww.tannoy.com.
tannoypro.com
6481 0599 / 1115
Tannoy operates a policy of continuous research and development. The introduction of new materials or manufacturing
methods will always equal or exceed the published specications. All specications are subject to change without notice.
Copyright (c) 2015 Music Group Innovation SC Ltd. All rights reserved.




