Quick Start Guide
Unpacking and Visual Checks
Every Tannoy VXNET product is carefully tested and
inspectedbeforebeingpackagedandleavingthefactory.
Afterunpackingyourloudspeaker,pleaseinspectforany
exterior physical damage, and save the carton and any
relevant packaging materials in case the loudspeaker
again requires packing and shipping. In the event that
damagehasbeensustainedintransit,pleasenotifyyour
dealerimmediately.
Rear Interface Panel
XLR FEMALE AUDIO INPUT - This is a lockable XLR
lineinputsocketforconnectiontotheaudiosource.Fully
balanced:pin2hot(+),pin3cold(+),&pin1ground.
XLR MALE AUDIO LINK - This is a lockable XLR line
outputsockettolinkadditionalspeakers.Fullybalanced:
pin2hot(+),pin3cold(+),&pin1ground.
ROCKER POWER SWITCH–TurnsACpower
ontotheunit(100V–240V)
FUSE HOLDER–Replaceonlywith10A230V
anti-surgefuse.TannoypartNumber34610919.
AC MAINS CONNECOR–NeutrikPowercon
mainsconnector(supplied)
USER DSP ON/OFF SWITCH
POWER LED–BlueLEDindicateswhenpower
hasbeenappliedtothespeaker.
LIMIT/NETWORK FOUND LED–Alsomounted
onthefrontofthecabinet.Thiscanbeseen
clearlyfrombehindthegrillwhenactivated.
SIGNAL PRESENT LED
System Configuration
All loudspeakers in the VXNET range are integrated
designswhichincludesystemspecicEQandprotection
circuitry, without the need for external amplication. For
room equalization, delay and other commissioning or
setup functions, we recommend you use a Vnet SC1
orTDX1Digital Controller.Pleaserefertothe fullVXNET
Seriesmanual.
AC Power Requirements
VXNET products are equipped with Neutrik powerCON
mainsconnectorswhichmatewiththeNeutrikNAC3FCA
Cable connector, providing quick lock with a securing
leveratpower-in.
This AC mains connector is supplied with each VXNET
product.
VXNET module in VXNET loudspeakers has a universal
power supply. It will operate on any AC mains supply
from100Vto250V(+/-10%)at50or60Hz,although
with reduced poweroutputcapability at the lowvoltage
extremes. This allows continued operation even when
using long, thin power cables, or when powered from
portablegeneratorsthatareunabletomaintainfullnominal
voltage.
Cooling
Do not install this equipment in an enclosed space. Do
notlimitfreeventilationand movementofair aroundthe
back panel. Ensure that there is at least 100 mm (4”)
of space around all sides of the product for ventilation.
VXNET products do not have cooling fans; the highly
efcient switch mode power supply and proprietary
ClassDoutputstagehavelowcurrentdrawandtherefore
requireonly the convection coolingprovided bythe rear
panelheatsink.




