Operation Manual

Knob A: Threshold, -40dBu to
20dBu in 0.2dB steps
Knob A: Output source, selectable;
Input A, Input B or Sum A+B
OUTPUT CHANNELS
Gain and Polarity Delay
As for input delay, velocity sensitive Parameter Knobs provide finer adjustment at low levels and rapid selection of higher values.
High and Low Pass Filters
Filter type is selectable from Butterworth, Bessel, Linkwitz-
Riley and Hardman. Filter slopes of up to 8th order or 48dB /
octave are provided. Not all filter types are available in all
slopes. For example 18dB / octave Linkwitz-Riley filters do
not exist.
The Hardman type filter is always described by its’ order as
the filter becomes progressively steeper rather than following
a linear slope so a dB/octave description is not accurate.
PARAMETRIC EQUALISATION
Eight sections of equalisation are provided in a similar format to the input channel equalisation; two shelving filters and
six parametric. The frequency is specified as point where the filter deviates by 3dB from the gain value.
Limiters
A high performance, low distortion limiter is provided on each
output. Threshold is user adjustable; all other parameters are
carefully calculated dependant on configuration to provide
clean and effective control of signal dynamics.
14
Knob A: Frequency,
<<out, 10.0Hz to 25.6kHz, out>>
Knob B: High pass filter type
Knob A: Gain, adjustable in 0.2dB
steps from –80 dB to +20dB
Knob B: Polarity, selectable,
normal or reversed with reference
to other outputs
Knob A: Frequency, 10.0Hz to 25.6kHz in variable steps
Knob B: Slope, 6 to 12dB / octave in 1dB steps
Knob C: Gain, +/-15dB in 0.2dB steps
Knob A: Centre Frequency, 10.0Hz to 25.6kHz in variable steps
Knob B: Width, display selectable, Q or BW (Bandwidth)
- BW adjustable from 0.05 to 5 octaves in variable steps
- Q adjustable from 14.2 to 0.2 in variable steps
Knob C: Gain, +/-15dB in 0.2dB steps
Knob A: Gain, adjustable in 0.2dB
steps from –80 dB to +20dB
Knob B: Polarity, selectable,
normal or reversed with reference
to other outputs
Routing
Configures the routing from input to output. This function
is only available in mono format Presets.
Out1 Gain Pol
0.0dB Rev
Out1 Freq Shape
LPF 2.50k LR24
Out1 Freq Slope Gain
EQ>- 100Hz 12dB 0.0db
Out1 Thresh
LIM 4.0dB
Out1 Source
Inp A
Out1 Freq Width Gain
EQ1 100Hz 1.4Q 0.0db
Out1 Delay
1.50ms