Operation Manual

* The VNET

interface allows networking of multiple VNET

speakers or SC1 controllers

Example 3: Using a network enabled VNET

SC1 to combine an existing Tannoy VNET

system with another loudspeaker

system (e.g. Tannoy PowerV)

STARTING UP

The unit will energise as soon as power is applied to the IEC inlet; there is no power switch. During the start up process the

firmware application model number and version numbers are displayed and the outputs are muted until the unit has

completed its internal checks. Once the start-up routines are complete and the unit is ready to pass audio. The DSP signal

path will be restored to the current settings when it was last powered down and the audio signal is gradually ramped up to its

correct level.

CREATING A CROSSOVER

The unit has two ‘Base Presets’; mono and stereo. These Base Presets are stored in locations 1 and 2 respectively; they can

be used to develop settings for any loudspeaker combination. They are recalled in the following way:-

Press Recall and use the left hand parameter knob A to scroll through the available base preset locations (as indicated by a

box symbol after the preset number). Once the appropriate base preset has been selected press recall again, at which point

you will be asked to confirm the action by pressing recall for a third time. This is to guard against accidental recall of presets.

The base presets are also locked but the user can name and store their own edited versions in any free preset location.

VNET

INTERFACE

VNET

SC1