Quick Start Guide

12 QFLEX WP Series Quick Start Guide 13
Mounting
QFLEX 64-WP
For mounting instructions and schematics, please refer directly to QFlex Operations Manual - available at Tannoypro.com.
5487.5
[216.04"]
825.5
[32.50"]
1405.5
[55.33"]
1985.5
[78.17"]
2515.5
[99.04"]
3095.5
[121.87"]
3584.5
[141.12"]
4204.5
[165.53"]
4824.5
[189.94"]
150.0
[5.91"]
171.5
[6.75"]
214.5
[8.44"]
64.5
[2.54"]
Assembly
Place each module in its respective position on the assembly area keeping them slightly spaced apart. Take the  ying RJ45 connector in the lower module and insert it
into the RJ45 socket in the upper module. Take the  ying AC mains connector in the lower module and insert it into the female connector in the upper module.
Align the two columns together as shown below.
Having the hinge points on either side of the QFlex column allow the loudspeaker to be rotated at 90 degrees to the mounting structure allowing easy access to
the input connector panel.
The installer must ensure that the mounting surface is capable of safely and securely supporting the loudspeaker. Seek help from architects, structural engineers or
other specialists if in any doubt.
POWER CORD
CAT 5
Attach the joining plates in the three stages as shown. Only one wall
bracket is required to mount the two modules. For  exibility the wall
bracket can be mounted to either the top or the bottom column. The wall
bracket can be hinged on the left or right pivot points. 3mm Allen grub
screws allow the QFlex to be locked at the desired horizontal angle.