Quick Start Guide

Quick Start Guide 1110 QFLEX WP Series
Unpacking
Every Tannoy QFlex product is carefully tested and inspected before being packaged and leaving the factory. After unpacking your loudspeaker, please inspect for any
exterior physical damage, and save the carton and any relevant packaging materials in case the loudspeaker again requires packing and shipping. In the event that
damage has been sustained in transit, notify your dealer immediately. Each QFlex carton is marked to show each modules position in the array.
Models
The Tannoy QFLex range is available in the following models/modules:
Model Modules
QFlex 16-WP 1x QFlex 16m + 1x Bracket Q ex-WP
QFlex 24-WP 1x QFlex 8m-1 + 1x QFlex 16sb + 1x Bracket Q ex-WP
QFlex 32-WP 1x QFlex 16sb + 1x QFlex 16m-1 + 1x Bracket Q ex-WP
QFlex 32LS-WP 1x QFlex 8m-32LS + 1x QFlex 8se-32LS + 1x QFlex 16st-32LS + 2x Bracket Q ex-WP
QFlex 40-WP 1x QFlex 8m-1 + 1x QFlex 16sb + 1x QFlex 16st + 2x Bracket Q ex-WP
QFlex 48-WP 1x QFlex 8s + 1x QFlex 8m-1 + 1x QFlex 16st + 1x QFlex 16sb-1 + 2x Bracket Q ex-WP
QFlex 64-WP 1x QFlex 8me-64 + 1x QFlex 8s-64 + 1x QFlex 16st-64 + 1x QFlex 16sb-64 + 1x QFlex 8se-64
+ 1x Q ex 8s2-64 + 1x Bracket Q ex-64-WP
Master 8 QFlex 8m-1
Master 8 QFlex 8m-1
Master 8 QFlex 8m-32LS
Master 8 QFlex 8m-1
Master 8 QFlex 8me-64
Slave 16 QFlex 16sb
Slave 16 QFlex 16sb
Slave 16 QFlex 16st
Slave 16 QFlex 16st-32LS
Slave 16 QFlex 16st
Slave 16 QFlex 16st-64Slave 8 QFlex 8s-64
Slave 16 QFlex 16sb
Slave 8 QFlex 8se-32LS
Slave 16 QFlex 16sb-1
Slave 16 QFlex 16sb-64
Master 16 QFlex 16m
Master 16 QFlex 16m-1
Slave 8 QFlex 8s
Slave 8 QFlex 8s2-64 Slave 8 QFlex 8se-64
QFlex 16-WP QFlex 24-WP QFlex 32-WP QFlex 32LS-WP QFlex 40-WP QFlex 48-WP QFlex 64-WP
Connections
NOTE: QFlex is a professional product intended for installation by properly quali ed and certi cated personnel.
Cable Management
All connections (AC, Network, and Signal) are accessed at the bottom of the QFlex column. This allows for neat, unobtrusive cable management in your installation.
The connectors will not be visible when installation is complete.Connections are accessed by the removal of the lower rear access plate on a QFlex master which will
require the use of a Philips screwdriver.
With the plate removed the connector areas look like this
End view
Top view
AUDIO A & B IN AUDIO A & B LINK SYSTEM
VNET/AES3 IN & LINK MAINS IN