Quick Start Guide

10. Tighten the four screws accessable from the front of the speaker, until all four clamps are holding the
speaker in place.
As the screws are tightened, the clamps rotate out of their rest postion and clamp to the
drywall/plasterboard.
Note: After installation, if the square ba e does not press  at against the drywall, insert a ½ " long screw in the oval
depression in each corner of the ba e, and hand-tighten until the ba e is  at against the drywall.
11. Install the square grille by pressing it into the square ba e. Small magnets hold it in place.
Clamp Screws (X4)
12. Alternatively, Install the circular grille by pressing it into the circular ba e. Small magnets hold it in place.
13. The grilles may be painted to match the decor, before they are  tted onto the speaker ba e.
14. Use the supplied square or circular masks to help protect the speaker cones when painting.
Painting Masks in Place
Insert extra screw here,
if required (see note)
29Quick Start Guide
28 QCI 3/QCI 8DC/PCI 8DC