Quick Start Guide

12. CAUTION: do not cut o the excess cable-tie length, or the clamps can no longer be reused. Instead, tuck the excess
length back into the slots and then re-install the three covers.
13. To remove the speaker at any time, remove the three covers, pull the cable-ties out of their tucked position, and then
press the tabs, and this will allow you to pull the speaker forwards and out of the hole.
14. Install the circular grille by pressing it over the speaker. Small magnets hold it in place.
Covers (X3)
Cable-ties (X3)
tucked
Magnets (X4)
15. Alternatively, install the square grille by pressing it over the square ba e. Small magnets in the speaker surround
and the square ba e hold it in place.
Note: After installation, if the square ba e does not press  at against the drywall, insert a ½ " long screw in the oval
depression in each corner of the ba e, and hand-tighten until the ba e is  at against the drywall.
Magnets (X8)
Insert extra screw here,
if required (see note)
25Quick Start Guide
24 QCI 3/QCI 8DC/PCI 8DC