Quick Start Guide

Wiring and Setting Up
Terminal Connections
1. WARNING: To avoid potential damage to your loudspeaker, ensure that the ampli er is switched OFF prior to
connecting or disconnecting any cables.
2. Before switching the ampli er ON, double check that all connections are secure and that the polarity is correct.
3. Note: For each speaker in this series, the correct square or circular ba e has to be  tted before connecting the
speaker wiring. (The ba es are  tted from behind, and so the speaker wires cannot be connected while the ba es
are being installed.)
4. The two screw terminals on the rear of each speaker are labled positive (+) and negative (-). These connect
respectively to the positive (+) and negative (-) output terminals of your audio power ampli er.
5. Strip o approximately 8 mm (¼ ") of the outer protective layer of one conductor and twist its inner cores
together to prevent shorting from stray wires. Insert the core into the screw terminal while ensuring that correct
polarity is maintained. Repeat this for both speaker wires. Tighten the two screws to make a secure connection.
6. The screw terminals for the QCI3 and QCI 8DC are located on the rear of each speaker. The screw terminals for the
PCI 8DC are located on the speaker frame. The PCI 8DC frame can be preinstalled and wired up, and the speaker
assembly added at a later stage.
QCI3 Terminals QCI 8DC Terminals PCI 8DC Terminals
21Quick Start Guide
20 QCI 3/QCI 8DC/PCI 8DC