Quick Start Guide

16 QCI 6DC/PCI 6DC/PCI 6DC LP Quick Start Guide 17
10. Tighten the four screws accessable from the front of the speaker, until all four clamps are holding the speaker in place. As the screws are tightened, the clamps
rotate out of their rest postion and clamp to the drywall/plasterboard.
Note: After installation, if the square bae does not press at against the drywall, insert a ½" long screw in the oval depression in each corner of the bae, and hand-
tighten until the bae is at against the drywall.
11. Install the square grille by pressing it into the square bae. Small magnets hold it in place.
12. Alternatively install the circular grille by pressing it into the circular bae. Small magnets hold it in place.
13. The grilles may be painted to match the decor, before they are tted onto the speaker bae.
14. Use the supplied square or circular masks to help protect the speaker cones when painting.
Clamp Screws (X4)
Insert extra screw here,
if required (see note)
Painting Masks in Place
Installation
PCI 6DC and PCI 6DC LP
1. WARNING: To avoid potential damage to your loudspeaker, ensure that the amplier is switched OFF prior to connecting or disconnecting any cables.
2. The procedure below describes the installation of the speaker into a typical stud ceiling with drywall/plasterboard. The PCI 6DC and PCI 6DC LP speaker frame is
installed and wired, then the speaker assembly can be added later.
3. Locate a suitable mounting position for the speaker, using a stud-nder. WARNING: Make sure that there are no power lines, other cables, or plumbing such as water,
sewer, gas lines in the chosen cutout location. Also make sure that the location is far enough from the closest wall stud so that the clamping mechanism can operate
without interference.
4. Use the supplied cutout template as a guide, and cut out a circular hole in the drywall/plasterboard. Remove any debris from the hole. Use a suitable adhesive in
the local area inside the hole to seal the drywall to the studs and joists, to prevent ceiling buzzing.
5. Run the speaker wire from your amplier to this location, leaving enough slack to allow for the connection.
6. To use the square speaker grille, rst move the mounting clamps out of the way as described in step 9 below. Remove the backing from the strips of double-sided
tape, and push the speaker frame into the supplied square bae.
7. To use the circular speaker grille, push the speaker frame into the supplied circular bae instead.
Cutout Installation Template
Speaker Frame Square Bae Speaker Frame with Square Bae
Speaker Frame Circular Bae Speaker Frame with Circular Bae