Quick Start Guide

18 QCI 6DC/PCI 6DC/PCI 6DC LP Quick Start Guide 19
8. Follow the information on the previous pages to connect the speaker wires from your power amplier to the speaker terminals on the speaker frame. Make sure to
check that the polarity is correct and that the positive and negative wires are securely and correctly connected. Secure the speaker wiring to the rear ring of the frame
with tie-wraps to prevent movement.
9. Carefully press the speaker frame into the cutout hole, making sure the speaker wires are not pinched. Reach inside the frame and rotate the clamps outwards and
pull the clamps forward on their rails to secure the speaker frame to the drywall/plasterboard. To remove the speaker frame from the hole, press the release tabs
and push the clamps back.
10. Use the supplied square or circular masks to help protect the speaker cones when painting.
11. The grilles can be painted separately.
12. To mount the speaker into the mounted speaker frame, align the connector on the speaker, with the corresponding connector on the speaker frame.
The outer ring of the speaker has an alignment guide channel that ts an alignment stub on the frame.
PCI 6DC Terminals
Clamps (X4)
Release
Rail
Clamp
Painting Mask in Place
Alignment guide
13. To lock the speaker in place in the frame, press down on the three lock buttons on the front of the speaker.
Note: After installation, if the square bae does not press at against the drywall, insert a ½" screw in the oval depression in each corner of the bae,
and hand-tighten until the bae is at against the drywall.
14. To unlock the speaker from the speaker frame, rst support the weight of the speaker, and rotate each lock with a screwdriver less than half a turn.
15. The HF switch has three positions, with 0 dB being at. Adjust as necessary to suit the room position and acoustic conditions.
16. Install the square grille by pressing it into the square bae. Small magnets hold it in place. Alternatively, install the circular grille
by pressing it into the circular bae.
Locks
Press in the Lock
Turn to unlock
Insert extra screw here,
if required (see note)
HF Switch HF Switch
0 dB +3 dB
+1.5 dB