Quick Start Guide

10 DVS EN54 Quick Start Guide 11
3. Standard Accessories
Cable Clamp Cover
Yoke Bracket (Supplied with xings) Bracket Clamp Tool
4. Installation Guidelines
1. Fix the yoke bracket to the
surface using a suitable
xing method.
2. Feed the speaker cable through
the cable clamp cover then
connect the Euro-type plug
to the wires, observing the
correct polarity.
3. For connection to the
loudspeaker, use Pins 1 (+)
and 2 (-). Pins 3 (-) and 4 (+)
are in parallel for connection
to additional speakers in a
distributed line.
4. Oer the speaker up to the
bracket and attach using
the screw caps then tighten
using the bracket clamp
tool provided.
5. Connect the Euro-type plug
then replace the cable clamp
cover to ensure the speaker
is sealed.
6. The DVS 4T (EN54)/-WH
models are tted with
30 W transformers.
The speaker is supplied
in low impedance mode.
never connect the speaker to a
70/100 volt amplier while it is
set for low impedance.
7. The DVS 6T (EN54)/-WH
models are tted with
60 W transformers.
The speaker is supplied
in low impedance mode.
never connect the speaker to a
70/100 volt amplier while it is
set for low impedance.