Quick Start Guide

102 CMS 3.0 Series Quick Start Guide 103
Accessories
Standard Accessories
Optional Accessories
C-Ring
Grille
Paint Mask
Cut-out template
Tile-bridge kit
Note: A tile-bridge kit
must always be used
when installing into
suspended ceiling tiles
Plaster (mud) ring
Installation Guide for Suspended Ceilings
1. Remove the ceiling tile from its frame and place it on a at surface. Position the cutout template
(self adhesive backed) on the tile. (Fig.1)
2. Cut out the hole in the ceiling tile using a pad saw following the broken line indicated on the template (Fig.2)
3. Place the C-Ring and tile-bridge on top of the ceiling panel, aligning the C-Ring over the hole, and screw the
C-Ring to the tile bridge using the xings provided. (Fig.3)
4. Go to the ‘Wiring and Setting Up’ chapter.
5. Slide the speaker assembly through the hole. Turn the screws (denoted “Screw Fix”) clockwise on the front of
the speaker to extend the mounting wings. Tighten the screws until a rm grip is achieved. (NOTE: Screws have
a PoziDriv head; use of a PoziDriv driver is recommended). If using a power driver, Tannoy recommends a torque
setting of 1.5 Nm. (Fig.4)
DO NOT OVERTIGHTEN!
6. Attach the nylon safety to the hooks on the front bae before attaching the grille by presenting it to the
speakers and allowing the magnets to pull it into position (Fig.5). (With the CMS 403DCe/ICTe, the grille is
already tted to the product.)
NOTE ON INSTALLATION OF CMS 403DCe/ICTe:
Before tightening the screws in step 5, swivel the speaker in the desired direction. When the screws are tightened, the speaker will lock into position. Replace the front
trim to conceal the mounting screws.
Fig.1
Fig.2
Fig.3
Fig.4
Fig.5