Quick Start Guide

14 PCI 7DC RB Quick Start Guide 15
Fig. 11. Installing the Grille
Fig. 10. HF Switch Positions
Fig. 9. Rotating the baffle assembly
HF Switch
+1.5 dB
0 dB +3 dB
Ba e Rotation
1. The loudspeaker ba e assembly can be rotated to alter the coverage to suit
your installation. This is the equivalent of "toeing in" free-standing speakers to
face your normal listening position.
2. Undo the four screws as shown, but just enough to allow the rotation to the
desired position (Fig. 9).
3. Gently tighten the four screws when done, just enough to prevent movement
during use. The ba e can be rotated through +/- 45 degrees.
4. Test the system and readjust the position if needed.
HF Switch Adjustment
1. The HF switch has three positions, with 0 dB being  at. Adjust as necessary to
suit the room position and acoustic conditions (Fig. 10.).
2. Test the system and reset the switch position if needed.
Grille Installation
1. The grille should be carefully  tted by lining up the edges of the grille carefully
with the ba e and frame inside edges (Fig. 11). To avoid indentation damage,
do not press the centre of the grille; apply even pressure to each corner as it is
pressed  rmly into position.
2. To remove the grille, loop an opened paper clip or similar length of firm wire,
through two holes near a corner and pull gently. The grille is intended to be
a tight fit, so insert the wire at each corner in turn, pulling carefully to avoid
distortion of the mesh.
System Testing
1. Switch on the ampli er with the volume control at its lowest setting. Select
a suitable signal source and slowly turn up the volume to a low level. Check
that the loudspeaker is working correctly and is in phase - if not, switch o the
ampli er and recheck the connections.
2. Carefully check the area surrounding the installation and listen carefully
to ensure that there are no buzzes or rattles that could potentially impair
enjoyment of the system. If there are, then locate and silence the causes using
cable ties or suitable packing material.
Dimensions
PCI 7DC RB
PCI 7DC RB Back Can
328 mm [12.9"]
328 mm [12.9"]
163 mm [6.4"]
350 mm [13.8"]
350 mm [13.8"]
700 mm [27,6"]
353 mm [13,9"]
Ø333 mm [Ø13,1
"]
333 mm [13,1"]
332 mm [13,1"]
190 mm [7,5"]