Quick Start Guide VQ 100/VQ 60 3 Way Dual 12" Large Format Loudspeaker for High Performance Installation Applications VQ 85DF/VQ 64DF 2 Way Down-Firing Dual Concentric Mid-High Loudspeaker for High Performance Installation Applications VQ 64MH 2 Way Dual Concentric Mid-High Large Format Loudspeaker for High Performance Installation Applications VQ MB Dual 12" Mid-Bass Large Format Loudspeaker for High Performance Installation Applications V 1.
VQ Series Important Safety Instructions Terminals marked with this symbol carry electrical current of sufficient magnitude to constitute risk of electric shock. Use only high-quality professional speaker cables with ¼" TS or twist-locking plugs pre-installed. All other installation or modification should be performed only by qualified personnel.
4 VQ Series Consignes de sécurité Les points repérés par ce symbole portent une tension électrique suffisante pour constituer un risque d’électrocution. Utilisez uniquement des câbles d’enceintes professionnels de haute qualité avec fiches Jack mono 6,35 mm ou fiches à verrouillages déjà installées. Toute autre installation ou modification doit être effectuée uniquement par un personnel qualifié.
6 VQ Series Instruções de Segurança Importantes Aviso! Terminais marcados com o símbolo carregam corrente elétrica de magnitude suficiente para constituir um risco de choque elétrico. Use apenas cabos de alto-falantes de alta qualidade com plugues TS de ¼" ou plugues com trava de torção pré-instalados. Todas as outras instalações e modificações devem ser efetuadas por pessoas qualificadas.
8 VQ Series Quick Start Guide Introduction The VQ 60, VQ 100 and VQ DF are fitted with 4-pole Neutrik Speakon´ connectors and barrier strip for fixed installations. The VQ full range products utilize a unique driver technology to radiate a coherent single point source for superior dispersion control when coupled to our single horn. This advanced design aligns the acoustical centres of the transducers providing a single coherent wavefront emanating from the throat.
10 VQ Series Cable Run Quick Start Guide Diameter of conductor Cable Resistance Wire Loss (dB) VQ Series Recommended Amplifier Power Damping Factor* m ft mm awg ohm 4ohm Load 8ohm Load 4ohm Load 5 16 1.5 mm 2.5 mm 4 mm 6 mm 15 10 6 3 0.10 0.04 0.01 0.01 0.2 0.1 0 0 0.1 0 0 0 40 108 255 494 8ohm Load ✓ ✓ ✓ ✓ 80 216 510 988 11 ✓ ✓ ✓ ✓ 10 33 1.5 mm 2.5 mm 4 mm 6 mm 15 10 6 3 0.20 0.07 0.03 0.01 0.4 0.2 0.1 0 0.2 0.
12 VQ Series Quick Start Guide 13 Flying A Single VQ Cabinet Using Eyebolts VQ Flying Bracket (Single Point Hang Flying Bracket) The simplest method of flying a single VQ cabinet is with a pair of M10 shoulder eyebolts on the top, using a third eyebolt on the rear of the cabinet to tilt the cabinet. For safe, flexible and simple flying, the VQ Flying bracket is designed to suspend the VQ cabinet from a single pivot point. This allows precise adjustment of aiming angles with the cabinet in situ.
14 VQ Series Quick Start Guide Remove the front two countersunk M10 screws located on the top of the cabinet and the top M10 countersunk screw on the top rear of the cabinet. Assemble the flying bracket as shown. (See fig. 1) VQ Link Plate IMPORTANT: Only the screws, fasteners, shake proof and plain washers supplied should be used to assemble the VQ flying bracket. Note: All fixings should be thread-locked and torqued to 25 Nm.
16 VQ Series Quick Start Guide Arraying VQ 60 A single VQ 100 can produce more power and clarity over its 100 degree beamwidth area than many arrayed solutions using multiple cabinets, a great advantage when considering your building aesthetics. A VQ 100 is not designed to be arrayed. Two VQ 60s can be arrayed to produce a well defined horizontal coverage angle of 120 degrees. The VQ array plate is designed to optimally array two VQ 60 cabinets.
18 VQ Series Quick Start Guide Specifications VQ 100 VQ 60 VQ 85DF System VQ 64DF VQ 64MH VQ MB System Frequency response (-3 dB) 115 Hz - 23 kHz 115 Hz - 23 kHz 400 Hz - 23 kHz Frequency response (-3 dB) 400 Hz - 23 kHz 400 Hz - 23 kHz 115 Hz - 500 Hz Frequency range (-10 dB) 90 Hz - 27 kHz 90 Hz - 27 kHz 350 Hz - 27 kHz Frequency range (-10 dB) 350 Hz - 27 kHz 350 Hz - 27 kHz 90 Hz - 600 Hz Sensitivity (1 W @ 1 m) 111 dB 115 dB 111 dB Sensitivity (1 W @ 1 m) 114 dB 115 dB
20 VQ Series Quick Start Guide Other important information Important information 1. Register online. Please register your new Music Tribe equipment right after you purchase it by visiting musictribe.com. Registering your purchase using our simple online form helps us to process your repair claims more quickly and efficiently. Also, read the terms and conditions of our warranty, if applicable. 2. Malfunction.
22 VQ Series Quick Start Guide FEDERAL COMMUNICATIONS COMMISSION COMPLIANCE INFORMATION Tannoy VQ Series Responsible Party Name: Music Tribe Commercial NV Inc. Address: 901 Grier Drive Las Vegas, NV 89118 USA Phone Number: +1 702 800 8290 VQ Series complies with the FCC rules as mentioned in the following paragraph: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
