Instructions / Assembly

Assembling the base to the septic cover
1. Locate the stainless steel hoop with the three straps fastened to it. Caution: Edges may
be sharp!
2. Feed the 90 inch assembled strap below the chains of the septic cover. Or you can
choose to fasten the stainless steel hoop as close to the ground as possible. Using a
helping hand, wrap the strap around the septic cover in a circle. Use the 2 inch carriage
bolt (included), a flat washer (included) and wing nut (included) to secure the ends of
the strap together.
3. Take the remaining three straps already fastened (each 1 foot in length) and stand them
straight upward.
Septic lid with the hoop installed properly.
4. Place the well base over the septic cover that you just installed straps onto. Bend the
foot long straps outward toward the well base.
5. Mark a spot to drill a hole inside of the elongated slot on the strap. (Make the mark on
the rock surfaces and not the grout line). Straps have elongated slots to allow height
adjustment, depending on high your septic cover is above ground.