Operation Manual

5
EN
♦
Auto Power Off
The scale is designed with an auto power-off function for energy efciency. If the same reading is displayed for
more than 10 minutes the scale will automatically turn off.
♦
Battery replacement
If “Lo” appears in the display when attempting to weigh, replace the battery. (following previous instructions)
Trouble shooting
• Thepowerdoesn’tturnon.
Insert 2 new size AAA (“R03” or “24F” ) batteries. Be sure that the polarity of the batteries is set properly.
•“Err6”or“Err7”appearsonthedisplay.
The scale needs to be repaired. Please contact your retailer.
• “Err1”or“Err8”appearsonthedisplay.
Place the container or item(s) only after 0 g/0.00 oz is displayed.
• Thescaledoesnotsettomicromode/Mmarkdisappearswhileoperating.
Minimum display is 1 g/0.05 oz when the total weight on the tray is 1000 g/35.28 oz or more.
Press
Micro
TARE
again after removing the weight.
• AlthoughMicroModewasselected,theweightofsomethinglessthan200g/7.05ozcannotbeshownin
0.1g/0.01ozincrement.
Has the scale display ever shown 0 g after pressing
Micro
TARE
during additional measurement? If the answer
is “Yes”,
that means the total weight on the scale has reached/exceeded 1000 g/35.28 oz. Once the total weight reached/
exceed 200 g/7.05 oz, the scale increment will automatically change to 0.5 g/0.02 oz even
if
Micro
TARE
is pressed
during additional measurement. By the same token, when total weight reached/exceeded
1000g/35.28oz, the
increment will change to 1g/0.05oz.
To reset the scale to Micro Mode, simply remove all the materials from the tray, then press
Micro
TARE
to show
0.0 g/0.00 oz.
Specification
g version g/oz version
Capacity 2000 g 2000 g / 70.5 oz
Graduation
Normal measurement mode 1 g 1 g / 0.05 oz
Micro mode
0 – 200 g 0.1 g
200 – 1000 g 0.5 g
0 – 200 g 0.1 g
0 – 7.05 oz 0.01 oz
200 – 1000 g 0.5 g
7.06 – 35.28 oz 0.02 oz