Safety data sheet

MSDS-No.: 41955
V001.7
Tangit Cleaner PVC-U/C ABS
Page 7 of 13
Derived No-Effect Level (DNEL):
Name on list
Application
Area
Route of
Exposure
Health Effect
Exposure
Time
Value
Remarks
Acetone
67-64-1
Workers
Inhalation
Acute/short term
exposure - local
effects
2420 mg/m3
Acetone
67-64-1
Workers
Dermal
Long term
exposure -
systemic effects
186 mg/kg bw/day
Acetone
67-64-1
Workers
Inhalation
Long term
exposure -
systemic effects
1210 mg/m3
Acetone
67-64-1
general
population
Dermal
Long term
exposure -
systemic effects
62 mg/kg bw/day
Acetone
67-64-1
general
population
Inhalation
Long term
exposure -
systemic effects
200 mg/m3
Acetone
67-64-1
general
population
oral
Long term
exposure -
systemic effects
62 mg/kg bw/day
Butanone
78-93-3
Workers
Dermal
Long term
exposure -
systemic effects
1161 mg/kg bw/day
Butanone
78-93-3
Workers
Inhalation
Long term
exposure -
systemic effects
600 mg/m3
Butanone
78-93-3
general
population
Dermal
Long term
exposure -
systemic effects
412 mg/kg bw/day
Butanone
78-93-3
general
population
Inhalation
Long term
exposure -
systemic effects
106 mg/m3
Butanone
78-93-3
general
population
oral
Long term
exposure -
systemic effects
31 mg/kg bw/day
Biological Exposure Indices:
Ingredient [Regulated
substance]
Parameters
Biological
specimen
Sampling time
Conc.
Basis of biol.
exposure index
Remark
Additional
Information
Butanone
78-93-3
[BUTAN-2-ONE]
Butan-2-one
Urine
Sampling time: End of
shift.
UKEH40BMG
V
8.2. Exposure controls:
Respiratory protection:
The product should only be used at workplaces with intensive ventilation/extraction. If intensive ventilation/extraction is not
possible then self-contained independent respiratory protection should be worn.
Hand protection:
For shorttime contact (1-5 minutes) protective gloves made from special nitrile rubber are recommended according to EN 374.
Material thickness > 0,2 mm
In the case of longer contact protective gloves made from butyl rubber are recommended according to EN 374.
material thickness > 0.7 mm
Perforation time > 240 minutes
In the case of longer and repeated contact please note that in practice the penetration times may be considerably shorter than
those determined according to EN 374. The protective gloves must always be checked for their suitability for use at the specific
workplace (e.g. mechanical and thermal stress, product compatibility, antistatic effects, etc.). The gloves must be replaced
immediately at the first signs of wear and tear. The information provided by the manufacturers and given in the relevant trade
association regulations for industrial safety must always be observed. We recommend that a hand care plan is drawn up in
cooperation with a glove manufacturer and the trade association in accordance with the local operating conditions.
Eye protection:
Goggles which can be tightly sealed.