User's Manual
Indicator Function
Power/Standby indicator
Power: Power on-The product in power o status, then push the power source button on rear panel at
“ON” position the LED indicator blinks one time and the startup sound from electric relay in the unit,
after about 2 seconds the amplier will be in working status. Note that the unit will remember the set-
tings from before it was powered o.
Power o:
Push the power source button at “OFF” position, then the close sound from the electric relay and unit
go into power o status.
Standby:
Press the standby button on the remote control, or push the Volume/selector button (3-4sec). Then the
unit will go into standby, and the standby LED will be red color. The unit is in standby status.
(When the Ampster goes into auto standby when inactive (no signal) in 15min, you can wake it up via bluetooth/
line in/ AUX signal) Wake up on same input as auto power down on.
Power on (from standby mode): Press standby on the remote control or push the Volume/selector button.
And after about 2 seconds the amplier will be in last time working status before standby.
Bluetooth input indicator
Press to select Bluetooth as your audio source.
Optical input indicator
Press to select input method as optical ber wired audio source.
AUX input indicator
Press to select input method as 3.5mm audio jack line in.
Line-in input indicator
Press to select input method as wired RCA Line-in.
Volume and input switch button
This selector can adjust volume (turn left or right) and also switch the input mode (push)
(For standby push and hold the button)
(UK)