User's Manual

element User Manual v1.17 rev1
6
10. Getting started
10.1 Connecting the panel to your computer
First make sure that the software you are going to
use the panel with is not running on your computer.
Use the supplied cable to plug the panel into a free
USB slot on your computer. The USB connector is on
the rear of the panel.
If all is well the display will show something similar to the following splash screen:
10.2 USB hubs and extenders (or repeaters)
You can use a USB hub to connect multiple panels to your computer. The important
thing to note is that the hub must be powered and must be able to provide 500mA to
each USB port simultaneously.
If you use an extender (or repeater) it must be able to supply 500mA.
11. Link pins
The two link pins that are provided are designed to
enable you to lock your Element panels together side
by side. The pins slot into the holes at either end of
the side of the panel. They are held in place by a
magnet that is at the bottom of the hole.
Due to the strength of the magnets you may need to use pliers or similar to remove the
pins.