Manual

the barrels could result in a bulged or burst barrel or other damage to the firearm
and could cause serious injury to the shooter or to others.
W A R N I N G
If there is any reason to suspect that a projectile is obstructing the barrel,
immediately unload the firearm (See Unloading Instructions) and check the chamber
and the bore. A projectile or some other matter may be lodged some distance
down the barrel where it can not easily be seen. Check the bore by using a
cleaning rod to pass through the barrel. If a blockage is in the bore, DO NOT
ATTEMPT TO SHOOT IT OUT WITH ANOTHER CARTRIDGE, OR BLOW IT
OUT WITH A BLANK CARTRIDGE OR A CARTRIDGE FROM WHICH THE
BULLET HAS BEEN REMOVED. SUCH TECHNIQUE(S) CAN GENERATE
EXCESSIVE PRESSURE, DAMAGE THE FIREARM AND CAUSE SERIOUS
PERSONAL INJURY. If the blockage can be removed with a cleaning rod, clean
any unburned powder grains from the bore, chambers and mechanism before
resuming shooting. If the blockage can not be dislodged by tapping it with a
cleaning rod, take the firearm to a gunsmith.
W A R N I N G (EYE AND EAR PROTECTION)
When shooting, full eye and ear protection is mandatory at all times. Shooters
and spectators must wear shooting glasses and hearing protection to prevent
eye injury and hearing loss. Vision and hearing impairment can occur with only
one moment of non-protection.
W A R N I N G (Mechanical Malfunctions)
STOP SHOOTING IMMEDIATELY AND UNLOAD YOUR FIREARM if your firearm
develops: a mechanical malfunction; binding or stoppage; spitting powder/gas; a
punctured cartridge primer; a bulged or ruptured cartridge case; or a sound on
firing does not sound quite right. Do NOT try one more shot but unload your
firearm and take it and the ammunition to a qualified gunsmith or send the firearm
back to European American Armory Corp. for examination. Do not assume that
the pistol is empty merely because you checked the chamber. You must also
check the bore for any fired bullet or obstruction inside the barrel.
BASIC PARTS AND OPERATION OF YOUR PISTOL
Hammer: The hammer is located on the rear of this
pistol and supplies energy to move the firing pin to
ignite the cartridge primer. See Figure 1.
Grip Safety: The grip safety is located on the back
of the grip in the upper area and blocks the trigger
which in turn blocks the hammer and sear. See Figure
Figure 1
9