Manual

Fig 1z
Fig 2z
Fig 3z
and that neither replacements nor originals are altered or changed. Your gun is a
complex tool with many parts that must relate correctly to other parts for safe
and accurate operation. Putting a gun together wrong or with modified parts can
result in a damaged gun, or personal injury or death to you or others. Always let
a qualified gunsmith work on your gun or at least, check any work not performed
by a gunsmith. Firearms safety is your primary concern. THE GUN OWNER
MUST ACCEPT FULL RESPONSIBILITY FOR THE CORRECT REASSEMBLY
AND FUNCTIONING OF THE FIREARM AFTER ANY DISASSEMBLY OR
REPLACEMENT OF PARTS.
TO CLEAN AND MAINTAIN YOUR PISTOL:
A) Follow procedures for unloading pistol as described previously.
B) Follow procedures for disassembly of pistol as described previously.
C) Materials needed to clean this pistol are: a cleaning rod, cotton bore patches,
brass bore brush, powder solvent, a small soft brush and good quality gun oil.
WARNING: Lead or lead compounds are known to the State of California to
cause cancer, birth defects, reproductive toxicity, and other serious physical
injury. Those who clean firearms should take protective measures to avoid contact
or exposure to such chemicals.
D) Using the bore brush with powder solvent, scrub the interior of the barrel and
chamber to remove any powder and lead residue in the bore. Always and lastly,
swab the interior of the barrel with cotton patch with gun oil to coat and protect
the bore and chamber from rust and corrosion.
E) Any powder fouling on the firing wall, barrel, etc. can be easily cleaned with a
brush and powder solvent.
F) All external surfaces should be wiped down with a light coat of rust preventative.
Avoid using too much oil as powder, dust or other foreign material may get trapped
in the oil. This could lead to congealed deposits which may interfere with the
safe and reliable operation of the pistol.
G) USE CAUTION while using solvents in gun bore cleaning. Prolonged or excess
contact with solvents can damage the gun’s bluing and finish. Be sure to wipe
away all excess solvent and then lubricate with oil.
H) A gun should be cleaned after firing. In addition, external parts should be
wiped with an oiled cloth after handling. A light oil is ordinarily all that is necessary
in cleaning if the gun has not been fired or fired very little. If a gun is used frequently,
it must be cleaned after each firing and regularly serviced by a professional
gunsmith. If the gun has been stored, remove all excess oil and/or grease before
16