User Manual
2
3
Notices about this User's Manual
In order to properly use this product, please carefully read this manual
before using. T&D Corporation accepts no responsibility for any
malfunction of and/or trouble with this product or with your computer
that is caused by the improper handling of this product and will deem
such trouble or malfunction as falling outside the conditions for free
repair outlined in the attached warranty.
- All rights of this manual belong to T&D Corporation. It is prohibited to
use, duplicate and/or arrange a part or whole of this User’s Manual
without the permission of T&D Corporation.
- Microsoft
®
and Windows
®
are registered trademarks of Microsoft
Corporation USA and are binding in the USA, Japan and all other
countries.
- All registered trademarks, company names, product names and logos
mentioned herein or for products being used are the property of T&D
Corporation or of their respective owners.
- Specications, design and other contents outlined in this manual are
subject to change without notice.
- Please follow the safety precautions outlined in the Manual carefully.
We cannot guarantee nor are we responsible for safety if this product
is used in any manner other than was intended.
- On-screen messages in this document may vary slightly from the actual
messages.
- Please notify the shop where you purchased this product or T&D
Corporation of any mistakes, errors or unclear explanations in this
manual. T&D Corporation accepts no responsibility for any damage or
loss of income caused by the use of our product.
- This product has been designed for private and/or industrial use only. It
is not for use in situations where strict safety precautions are
necessary such as in connection with medical equipment, whether
directly or indirectly.
- We are not responsible for any malfunction or trouble caused by the
use of our product or by any problem caused by the use of measure-
ment results of our product.
Please be fully aware of this before using our product.
- This manual cannot be reissued, so please keep it in a safe place.
- Please read the warranty and provisions for free repair carefully.
Compliance Information
Radio, EMC and Safety Regulations
This device complies with Part 15 of the Federal Communications Commis-
sion (FCC) rules. Operation is subject to the following two conditions: (1)This
device may not cause harmful interference, and (2)this device must accept
any interference received, including interference that may cause undesired
operation.
FCC Statement
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment o
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit dierent from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
To comply with the limits for the Class B digital device, pursuant to Part 15 of
the FCC Rules, this device must be installed in computer equipment certied
to comply with the Class B limits.
All cables used to connect the computer and peripherals must be shielded
and grounded. Operation with non-certied computers or non-shielded
cables may result in interference to radio or television reception.
Caution:
Changes or modications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.