User's Manual

・
If the connector on your computer is a D-SUB 9 pin male then there is
no need for an adapter.
・
If the connector on your computer is a D-SUB 25 pin female then use
an adapter (D-SUB 25 pin male to a D-SUB 9 pin male).
・If the connector on your computer is a Half pitch 14 pin female then use
the adapter (Half pitch 14 pin male to a D-SUB 9 pin male) or a
combination (Half pitch 14 pin male to D-SUB 25 pin male) and (D-SUB
25 pin female to a D-SUB 9 pin male).
73
Troubleshooting
Q: I can’t get the communication cable connected to the computer.
What should I do?
A: Please connect the communication cable provided with the Thermo
Recorder into the serial port of your computer (D-SUB 9 pin male
connector). If for some reason you cannot connect directly, please use
an appropriate adapter (gender changer plug) as explained below.
Q: I can’t download settings and/or data from the Thermo Recorder
to my computer. What should I do?
A: Check to make sure that the power of the main unit is ON.
A: Check to make sure that the connection is proper. Communication
will take place only through the serial port (RS-232C) and will not
work through the printer port or any other port.
A: Check to make sure that you can control the Thermo Recorder via
the software.
A: Make sure that the serial port has been selected correctly in the
[Communication] pull down menu in the software. Please check
which port you are connected to (COM1-COM8) and select
appropriately.
A: If you have access to another computer, try to see if you can download
using it.