User's Manual

9
[
Auto Detection
]
■
Setting Up the Serial Port
Set the serial port to be used for communication with the data logger.
There are two ways to set up the serial port [Auto Detect] and [Select a
Port].
●
When you wish to use the same COM port to carry out communication
with different types of units.
Check [Set Common COM Port for All Types] and click the [OK] button to
complete at once the port setting for all types of units.
１.In the main window, open the setting, communication display of the
type of data logger connected to the computer and click the [Serial
Port Settings] tab.
２.Click the [Auto Detect] button to start the detection process.
３.When the detection is completed, a message will be displayed in the
[Detection Results] section.
４.By clicking the [OK] button, the setting process will be nished and
the port to which the data logger is connected will be set.
５.By clicking the [Close] button, the setting will be completed.
[
Close
]
button
[
OK
]
button
[Auto Detect]
button
When setting up more
than one type at the
same time
Detection
Results
[
Serial Port Settings
]
tab