User's Manual

ŷŪ

Do not use or store the unit in places such as listed below:

Doing so may cause electrocution, ﬁ re and/or other adverse effects to the device

and/or your computer.

- Areas exposed to direct sunlight

This will cause the inside of the device to become overheated and may cause ﬁ re,

deformation, and/or other damage including malfunction.

- Areas prone to strong magnetic ﬁ elds

This may cause damage including malfunction.

- Areas exposed to water leakage

This may cause electrocution or other damage including malfunction.

- Areas exposed to excessive vibration

This may cause injury, malfunction, damage or loss of proper electrical contact.

-Areas that are not ﬂ at or level

This may cause the unit to fall and result in injury and / or damage.

-Areas near ﬁ re or exposed to excessive heat

This may cause damage including malfunction and deformation.

-Areas prone to smoke, dust and dirt

This may cause damage including malfunction.

Wireless Regulations

This device complies with part 15 of the Federal Communications Commision (FCC)

rules. Operation is subject to the following conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that may

cause undesired operation.

Note:

This equipment has been tested and found to comply with the limits for a Class A digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference when the equipment is operated in a commercial

environment. This equipment generates, uses, and can radiate radio frequency energy and,

if not installed and used in accordance with the instruction manual, may cause harmful

interference to radio communications. Operation of this equipment in a residentional area

is likely to cause harmful interference in which case the user will be required to correct the

interference at his own expense.

Changes or modiﬁ cations not expressly approved by the party responsible for

compliance could void the user's authority to operate the equipment.

This device complies with RSS-210 of the Industry Canada (IC). Operation is subject to the

following two conditions:

(1) this device may not cause interference, and (2) this device must accept any interference, including

interference that may cause undesired operation of the device.