User's Manual

IJĸ
External Output
ɡ Connecting the Signal Wire
1.
Prepare a ϫ 0.5 ȡ 0.9 single type wire and remove the covering to about 10mm from
the tip.
2.
Using a screwdriver or other such tool, while pressing down on the terminal button <B>
at the back of the unit, insert the wire into the hole <A>.
=A?
=B?
ȴEnlarged view of Wire
Connection Terminal ȵ
ɟ External Output : With Warning ON
Voltage when OFF: AC/DC less than 50V
Current when ON: less than 0.1A
Resistance when ON: 35 Ϯ
ɟ Useable Wires
Compatible Wires: Single wire: ϫ 1.0(AWG18) / Twisted wire: 0.75mm2
Useable Wires Single wireȤϫ 0.4 ȡϫ 1.0(AWG26 ȡ 18)
Twisted wireȤ0.3mm2 ȡ 0.75mm2(AWG22 ȡ 20)
Cable core diameterȤϫ 0.18
Standard Stripping Length 0.39in
Compatible Connector Tool: Screwdriver (Shaft: ϫ 0.3 / Blade Tip Width: 2.6)
ɡ Removing an Input Signal Wire
If you wish to remove an input signal wire, press down on the <B> button with a screwdriver and
pull out the wire.
NOTE:
Please be careful when pulling out the wire.