User's Manual

ĺĴ
ɜ [Notifi cation Test] button
Use this to send a test mail from the RTR-5W to the notifi cation address and confi rm that the
warning notifi cation settings are correct.
A notifi cation test is successful if a notifi cation test mail reaches the notifi cation address. If
it does not reach the set address, please check the SMTP server, Notifi cation Address, and
Sender Address settings.
If you are sending mail via the Internet, it is necessary to fi rst make sure that your network is
properly connected to the Internet and you can send mail outside of your network.
Depending on your operating environment, it may take some time before the mail is
received.(Especially if the address is a cell phone address.)
ɡ Before carrying out a notifi cation test, it is necessary to make settings for the
following:
-There must be a check next to Warning ON and proper entries must be made for ȨNotifi cation
Addressȩ and ȨSender Addressȩ.
-In the [Network Settings Utility], the SMTP server (mail server) must be assigned properly. (If
you have questions, see the information provided by your provider).
-It should be noted that if you assign an imaginary address, in some cases the SMTP server
will judge the mail to be SPAM or junk mail and not allow it to be sent. Please use your own mail
address.
ɜ Viewing the Warning Log: From ([View] – [View Log])
In the warning log will appear all warning occurrences.
Due to timing problems, there may be instances when a warning cannot be stored into the
computer. For details, see the Help for [RTR-5W for Windows].
The logs are in CSV format which can be read by common spreadsheet software and saved as
text fi le.