User's Manual

ĺij
ɡ Notifi cation Settings
-Amount of send rest time after sending warning report mail
Warning report mail will continue to be sent until the warning settings have been changed or the
measured value falls back within the acceptable range, but it is possible to make settings here for a rest
period to occur after a warning mail has been sent, so that they will not continually be sent. By entering 0,
there will be no rest period.
-Notify of a communication failure for monitoring warnings
Place a check here if you wish to have communication failure reports sent to the recipient address(es).
-Switch external output to ON when a warning occurs
If you wish to have an alarm or warning lamp that is connected to the external output go on when a
warning occurs.
9.
Click the [Set] button to send the settings info to the RTR-5W and complete the
settings.
[Set]
button
[Notifi cation Test]
button